Smoke alarms Gold Coast homes need for the 2027 rule
Smoke alarms Gold Coast homeowners and landlords already have on the ceiling may or may not meet Queensland’s 1 January 2027 rule, and the quickest way to find out is to check them. This page gives you five checks you can do in a few minutes, then explains what to order if your alarms fall short.
Super Cheap Smoke Alarms sells interconnected photoelectric alarms from RED Smoke Alarms and Emerald Alarms and posts them to every Gold Coast postcode by Australia Post. Call (07) 3155 5017 or use the contact page if you get stuck on any of the checks.

What the 2027 rule asks of Gold Coast homes
The Queensland Government says that by 1 January 2027, all existing private homes, townhouses, units and manufactured homes in Queensland must have interconnected photoelectric smoke alarms. Registered caravans and motorhomes must also have a photoelectric smoke alarm. The same rule applies on the Gold Coast as everywhere else in the state; there is no separate local version. Read the official page on qld.gov.au, or our plain-English 2027 deadline explainer.
Five checks for the smoke alarms Gold Coast homes have now
Grab a step ladder and a torch, and check one alarm at a time. Stop and plan a replacement as soon as an alarm fails any check.
1. Look for the standard. The label should show AS 3786:2014. If it doesn’t, the alarm doesn’t meet the rule.
2. Find the age. Look for the date of manufacture or date code on the label. The Queensland Fire Department (QFD) says to replace alarms that are more than 10 years old.
3. Check the sensor type. The rule calls for photoelectric alarms, and QFD says to replace any alarm that contains an ionisation sensor. The label or the maker’s details for that model will tell you which sensor it uses. If you can’t find out, treat it as a replacement.
4. Test the link. Press the test button on one alarm. If every alarm in the home sounds, they’re interconnected. If only the one you pressed sounds, they aren’t, and QFD says alarms that aren’t interconnected need replacing.
5. Note the power type. Is the alarm wired into the ceiling with mains power, or does it run on a battery? This decides what you can replace it with (see below).
Replacing hardwired alarms on the Gold Coast
If check 5 shows your alarms are hardwired, QFD is clear on two points. Hardwired smoke alarms must be installed by a qualified electrician, and if your current alarms are hardwired, the replacements must also be hardwired.
That means you’ll want a 240V model, such as RED’s R240RC, and an electrician booked to fit it. Order the alarms first so the electrician has them on the day. If only some of your alarms are hardwired, mention that when you ask us or your electrician, so the whole set can still be linked.
Battery and wireless alarms: the simpler swap
If your current alarms run on batteries, or a room that needs one has none, wireless interconnected alarms are the simpler path. QFD says wireless alarms have a non-removable 10-year battery, connect without wiring, and can be installed yourself.
Our wireless models are RED’s R10RF, the R10RFP from the RED Professional range, and Emerald’s EVO10RF from the Emerald range. Multi-packs include free remote controllers and magnetic mounting plates. Every alarm is covered by the manufacturer’s warranty: 10 years from the date code on RED, and up to 10 years from the date code on Emerald.
Where the smoke alarms Gold Coast homes need must go
QFD’s placement list is short. Alarms must be installed in every bedroom, in every hallway or room connecting bedrooms, and on every storey of the home. Walk through room by room and tick off each one.
Units, townhouses and houses all follow the same list. A high-rise unit on one level is usually bedrooms plus the connecting hallway. A split-level house or a townhouse needs every storey covered, even one with only a garage or living area. Our Brisbane page has three worked counts if you want to see the method in action.
If you rent out a Gold Coast property
Owners and property managers have set duties under the Residential Tenancies Authority (RTA) guidance. The owner or manager tests the alarms within 30 days before a tenancy starts or is renewed, and replaces flat or nearly flat batteries. The tenant tests and cleans them at least once every 12 months, replaces flat batteries during the tenancy, and reports any problem.
Neither side may remove an alarm or make it less effective. If you’re selling instead, our post on smoke alarms and selling property in Queensland is a good place to start, and owners will find more in our landlord guide.
Posting smoke alarms Gold Coast-wide: postcodes and suburb pages
We post to every Gold Coast postcode, from 4207 in the north to 4228 in the south. Some suburbs have their own page with more detail:
- Hope Island (4212) and Sovereign Islands
- Main Beach (4217), Benowa (4217), Benowa Waters and Paradise Waters
- Broadbeach Waters (4218) and Mermaid Beach (4218)
- Tallai (4213) and Palm Beach (4221)
Standard delivery takes 4 to 7 business days and costs $14.95, or it’s free on orders of $200 and over. Express takes 1 to 3 business days for $19.95. Prices include GST, and you can pay by card, PayPal, Klarna or Link in the shop.
Frequently asked questions
Does the Gold Coast have its own smoke alarm rules?
No. The Queensland rule applies statewide, including the Gold Coast.
My alarms are photoelectric but not linked. Can I keep them?
QFD says to replace alarms that are not interconnected, so they’ll need replacing with interconnected alarms.
Can I mix wireless and hardwired alarms?
Ask us before you order with your mix of alarms. QFD’s rule is that hardwired alarms are replaced with hardwired ones, and every alarm in the home must sound together.
How do I tell if an alarm is more than 10 years old?
Check the date code or date of manufacture on its label. If there’s no date at all, plan to replace it.
Do you post to apartments and gated estates?
We post by Australia Post to any address it delivers to. Add unit numbers and any delivery notes at checkout.
This page is general information, not legal advice.
Sources
- Queensland Government, “Smoke alarms”: https://www.qld.gov.au/emergency/safety/fire/smoke-alarms (page last updated 29 Oct 2026; checked 2 Nov 2026)
- Queensland Fire Department, “Smoke alarm laws are changing in Queensland” fact sheet (QFE00206, 05/26): https://www.fire.qld.gov.au/sites/default/files/2026-06/Smoke-Alarm-Fact-Sheet.pdf (checked 2 Nov 2026)
- Residential Tenancies Authority, “Smoke alarm laws: what you need to know in Queensland”: https://www.rta.qld.gov.au/news/2020/08/12/smoke-alarm-laws-what-you-need-to-know-in-queensland (checked 27 Oct 2026)
- Gold Coast postcodes: Australia Post postcode search, auspost.com.au/postcode (checked 27 Oct 2026)
- Manufacturer warranties: redsmokealarms.com.au/warranty and emeraldalarms.com.au/warranty (checked 2 Nov 2026)
Questions about smoke alarms on the Gold Coast?
Not sure which alarms suit your home, or how many you need? Tell us about your place through the contact page or call (07) 3155 5017, and we’ll help you choose. Browse the smoke alarm shop for wireless and hardwired alarms, delivered anywhere in Australia.
